Honeywell has introduced a bug in the new firmware that has broken the outside temperature/humidify display. This is not a problem of having incorrectly registered my thermostats, and it's not a problem of needing to wait for synchronization. So it appears that the software update installed on the new thermostats broke the outside temperature/humidity display just as it had done to the other thermostat about three months ago. Once the software update was installed, they started displaying 'Waiting for update' where they previously displayed the outside temperature/humidity. However, after about 20 minutes, both of the new thermostats downloaded a software update and restarted themselves. As soon as I got these thermostats installed, connected to Wi-Fi and registered with MyTotalConnectComfort, they started displaying the correct outside temperature/humidity. As described below, I believe a software update introduced the problem. I made no change to my registration information or zip code. It displayed the correct outside temperature/humidity until about three months ago when it started displaying 'Waiting for update.' It has been in that state continuously since then. I purchased the first thermostat about 18 months ago. Update amazon now offers a free smart home consultationĪnswered go to this thread to see the answer All three have good Wi-Fi Internet connections, all three are registered with MyTotalConnectComfort, and all three are displaying 'Waiting for update' where they should display the outside temperature and humidity.
0 kommentar(er)
